Delrin® 525GR is a 25% glass reinforced acetal homopolymer for injection molding. It has very high strength, stiffness, and high deflection temperature, and excellent creep resistance. Delrin® is the crystalline thermoplastic of choice for impact and wear resistance in a wide range of industrial and mechanical applications. With low, consistent internal stress, the material is easily machined and fabricated, experiencing little dimensional change during machining and use.
Contact us today for your fabrication and machining needs!
Request Fabrication/Machining ServicesGeneric Name
Polyoxymethylene, Polyacetal
Available In
Resin
Start Your Quote
Send us a message:
*Required Fields
Give us your cut-to-size dimensions. We will precision-cut these plastics to your exact size. Additional sizes and colors available upon request.
Physical Properties | Units | ASTM | Results |
---|---|---|---|
Density | kg/m3 (g/cm3 ) | ISO 1183 | 1600 (1.60) |
Mechanical Properties | Units | ASTM | Results |
---|---|---|---|
Tensile Strength | MPa (kpsi) | ASTM D 638 | 5mm/min (0.2in/min) - 151 (21.9) |
Elongation at Break | % | ASTM D 638 | 5mm/min (0.2in/min) - 3.2 |
Tensile Modulus | MPa (kpsi) | ASTM D 638 | 5mm/min (0.2in/min) - 9000 (1310) |
Flexural Modulus | MPa (kpsi) | ASTM D 790 | 8000 (1160) |
Izod Impact | J/m (ft lb/in) | ASTM D 256 | 96 (1.8) |
Unnotched Impact | J/m (ft lb/in) | ASTM D 4812 | 1100 (20.6) |
Thermal Properties | Units | ASTM | Results |
---|---|---|---|
Heat Deflection Temperature | °C (°F) | ASTM D 648 | |
0.45MPa (66psi), Not Annealed | 177 (351) | ||
1.8MPa (264psi), Not Annealed | 173 (344) | ||
CLTE, Parallel | ASTM E 831 | E-4/C | |
23 - 55C (73 - 130F) | 0.29 | ||
CLTE, Normal | ASTM E 831 | E-4/C | |
23 - 55C (73 - 130F) | 0.83 |
Electrical Properties | Units | ASTM | Results |
---|---|---|---|
Surface Resistivity | ohm | ASTM D 257 | 2 E15 |
Volume Resistivity | ohm cm | ASTM D 257 | 4 E13 |
Dielectric Strength, Short Time | kV/mm (V/mil) | ASTM D 149 | |
3.2mm (0.126in) | 17.3 (440) | ||
Dielectric Constant | ASTM D 150 | ||
1E6 Hz | 3.8 | ||
Dissipation Factor | ASTM D 150 | ||
1E6 Hz | 0.0076 |
NOTE: The property values presented above are typical values intended for reference and comparison purposes only. They should NOT be used as a basis for design specifications or quality control. Contact us for manufacturers’ complete material property datasheets. All values at 73°F (23°C) unless otherwise noted.