The first cast nylon to combine both molybdenum disulphid (MoS) and oil for the load capacity of Nylatron GSM PA6, plus improved frictional characteristics. It excels in higher pressures, and at low speeds-up to 40 fpm. It offers 20% lower coefficient of friction, 50% greater limiting PV, and a lower “k” factor than Nylatron GSM PA6, making it ideal for slide pads, thrust washers and trunion bearings. Nylatron GSM Blue PA6 should be considered for any oil-filled nylon application. It is dark blue in color.
Do you need Fabrication or Machining for Nylatron GSM Blue PA6?
Contact us today for your fabrication and machining needs!
Request Fabrication/Machining Services
At a Glance
Generic Name Polyamide
Available In Sheet, Rod
Start Your Quote
Send us a message:
1/16″ – 2″ TH
12″ x 24″, 24″ x 48″, 12″ x 48″
3/16″ – 2″ DIA
Give us your cut-to-size dimensions. We will precision-cut these plastics to your exact size. Additional sizes and colors available upon request.
Water Absorption. 24 hrs
Elongation @ Break, 73°F
Flexural Strength, 73°F
Flexural Modulus, 73°F
Compressive Strength @10%
Flexural Yield Strength
Maximum Service Temperature
Service Resistivity per Square
NOTE: The property values presented above are typical values intended for reference and comparison purposes only. They should NOT be used as a basis for design specifications or quality control. Contact us for manufacturers’ complete material property datasheets. All values at 73°F (23°C) unless otherwise noted.
Good mechanical and electrical properties
Ideal balance of strength and toughness
Cast as finished parts and near net shapes
Request a Quote TodayA member of our team will get with you right away!Request a Quote »