Saw Cut edge is the standard edge finish for all cut acrylic. It is chip free and does not need polishing if you’re engaging the edge.
The acrylic is run through a high speed joiner for a frosted edge which produces a “modern look” – and a low cost finish with no saw cuts.
The edges are milled and then pass an 800° F flame over the edge to a high luster – great for the typical acrylic application such as a tabletop. Do not clean flame polished acrylic with Windex, alcohol, or any ammoniated cleaners.
Machine polishing is a low cost and low stress polishing for thicker acrylic. It is ok to silk screen the material during the process.
Hand polishing is done by milling the edges to remove saw cuts, then sanding through four different grits of wet-dry sandpaper, then buffing with a cutting polish, then buffing with a fine polish. The result is a stunning Museum quality edge finish.
A bevel is typically used to soften the edge of a piece for the sake of safety, wear resistance, or aesthetics; or to facilitate mating with another piece.
A bevel is typically used to soften the edge of a piece for the sake of safety, wear resistance, or aesthetics; or to facilitate mating with another piece.
A smooth curved edge stopping halfway down the edge.
A roundover of the top and bottom edges.
Start Your Quote
Send us a message:
*Required Fields